A Quick Guide to Kronotex Laminate Flooring Installation

Kronotex is a renowned flooring brand and its laminate flooring is considered one of the best in the industry. The enormous variety of Kronotex laminates suits all kinds of ambience, interior decorating styles and everyday needs. The colours, creative patterns, perfectly emulated wood grain and finishes make them a much sought-after flooring product worldwide.

These robust laminates from Kronotex are also very easy to clean and install. They’re available in a practical snap-together system which you can install yourself without any special knowledge or have to call for professional help. If you’re searching for easy-to-understand instructions to install Kronotex laminates in your space, then you’re in the right place. In this post, we’ll provide you with a quick guide to Kronotex laminate flooring installation.

Prepare Correctly

There are several things to consider before you start the installation process.

  • Get the right dimensions of your room and note any special structural or architectural characteristics. Also, make sure to check the preferred thickness of the flooring and the availability of tools and materials.
  • For snap-together systems, you may need to have a proper underlayment installed which is available in various materials to fit different requirements. To insulate against noise and impact sounds, especially on mineral substrates, you should use a vapour barrier before underlayment installation.
  • Don’t store Kronotex laminate planks standing against the wall as it can cause them to bend and deform preventing them from fitting together correctly. Keep them laying down flat on the floor.
  • Acclimatize the products without opening the package in the room where they’ll be installed for at least 48 hours. This will help in preventing subsequent buckling and deformation.
  • Use one package at a time before opening a new one and make sure to check if they’re of the right size and appearance. Don’t use specific planks if you find visual or mechanical defects.

Step-by-step Instructions to Follow

Proceed with the installation once your subfloor is ready (it’s level, dry and clean) and the laminate planks are acclimated.

  1. If you have a concrete subfloor, lay a moisture barrier first parallel to the laminate planks. Overlap sheets of the moisture barrier by 20 cm and glue them together tightly to prevent moisture penetration.
  2. Place sheets of acoustic underlayment perpendicular to the direction that the laminate planks will be laid. Attach the underlayment sheets together with sticky tape.
  3. Start laying the first row of laminate planks from a corner of the room so that they run parallel to a light source such as a window or other sources. Leave a gap of 10-15 mm between the planks and click together their short sides. Wood wedges make excellent spacers. When you need to shorten the last plank, make sure that its length isn’t shorter than 40 cm. You may need to adjust the first panel accordingly.
  4. Take the left over from the first row and start laying the second row of planks by clicking that piece into the edge of the first plank. Angle the piece at about 12 degrees and then press it down.
  5. Continue the process similarly for the rest of the room.
  6. Trim the last row of the planks if they’re too wide leaving sufficient space along the wall.
  7. Trim the excess membrane of the skirting boards with a mitre saw before attaching.
  8. Remove the spacers along the walls, cover the excess moisture barrier sheets and fill the gap between the wall and the planks by installing baseboards. Cover the nail heads with wood putty.

Follow these instructions and easily install your Kronotex snap-together laminate flooring all by yourself. If you’re wondering where to buy Kronotex laminate flooring that’s authentic in Toronto, contact Amazon Hardwood. We are one of the largest dealers of branded flooring products serving across the GTA.

Leave a Reply

Your email address will not be published. Required fields are marked *